Functions With Ptt Switch - PRESIDENT BARRY II Manuel D'utilisation

CB is a "simplex" communication mode, it is not possible to speak
and listen at the same time (as it is the case with a telephone).
Once the conversation was over, he said "Roger" in order to
prevent his correspondent that it was his turn to talk. The word
"Roger" has been replaced by a significant beep. That is where
the name "Roger beep" comes from.
- Turn on the power while pressing the s key (3a) or UP knob (12)
to alternate between enable (On) or disable (OF) the ROGER BEEP
function.
When function is activated, " " appears on the display.
-
Note: The Roger beep also sounds in the loudspeaker if the KEY
BEEP function is active. If the KEY BEEP function is not active, only
the correspondent can hear the ROGER BEEP.
In PA mode the function is not allowed.
2) KEY BEEP
(t key on the unit or DN knob on microphone)
Some operations such as changing channels, pressure on keys etc.
are confirmed by a beep tone. This beep tone can be activated
or deactivated as follows:
Turn on the power while pressing the t key (3b) or the DN knob
-
(12) to alternate between enable (On) or disable (OF) the KEY BEEP
function.
When function is activated, "BP" appears on the display.
-
3) F - FREQUENCY BAND SELECTION
(Configuration: EU; PL; d; EC; U; In)
The frequency bands have to be chosen according to the country
of use. Don't use any other configuration. Some countries need a
user's licence. See table page 68.
Proceeding:
- Turn on the power while pressing the F key (5).
The symbol corresponding to the current configuration is blinking.
- In order to change the configuration, use the s/t keys (3) on the
unit or the UP/DN knobs (12) on the microphone.
When the configuration is selected, press the F key (5) during 1
-
second. The symbol corresponding to the configuration is contin-
(F key)
35
uously displayed and a confirmation tone beep sounds.
- At this point, confirm the selection by switching off the transceiver
and then switching it on again.
See the configurations/frequency bands table at pages 64 to 66.
4) COLOR
(MODE + EMG keys)
Turn on the power while pressing the MODE (6) and EMG (7) keys.
-
The symbol of the current color, among the seven, blinks:
ange), (green), (blue),
(cyan light).
- Use the s/t keys (3) on the unit or UP/DN knobs (12) on the mi-
crophone to change the color.
When the color is set, long press the F key (5). A beep sounds, the
-
characters of the color are displayed during 1 second.
5) RESET
Turn on the power while pressing the EMG key (7) to reset to the
-
factory settings.
- "rS" blinks in the display.
Press the F key (5) for 1 second to confirm.
-
D) FUNCTIONS WITH PTT SWITCH
4 more functions are available. To activate the function press and
hold the PTT switch (11) and press the function key. Repeat this
process to deactivate the function.
1) TALKBACK
(PTT + F)
The TALKBACK function can be activated or deactivated as follows:
a) Press and hold the PTT switch (11)
b) Short press on F key (5). Current TALKBACK level blinks 3 times
allowing you to adjust this level.
When function is activated, "TALKBACK" appears on the display.
This function allows to ear your own modulation with the CB speaker.
(cyan), (yellow), (purple) or
(or-