Num'axes SL1008 Guide D'utilisation page 57

•
Press [OK] then press the [UP] or [DN] button to select
the desired resolution.
•
Press [OK] to save your selection, then the letters "T" and
"ᴜ" will be blinking. Press the [OK] button to enter the
video length setting or the [M] button to exit.
Setting the Video Length in PIR mode
Your camera can be programmed to record from 5 seconds
(00:05) to 10 minutes (10:00) of video per trigger.
•
After pressing [OK] to confirm the Video resolution
setting, the letters "T" and "ᴜ" will be blinking on the
status display.
•
Press [OK] once to enter the video length setting.
•
Press the [UP] or [DN] button to select the desired video
length from 5 seconds (00:05) to 10 minutes (10:00) in
5-second increments.
•
Press [OK] to save your selection then the time out "T-O"
will be blinking. Press the [OK] button to enter the time
out setting or the [M] button to exit.
Setting the Time Out in PIR mode
You can select the length of time that the camera will "wait"
until it responds to any additional triggers from the PIR after an
animal is first detected and remains within the sensor's range.
•
After pressing [OK] to confirm the Burst Shoot or Video
Length setting, "T-O" will be blinking on the status display.
•
Press [OK] to enter the Time Out setting.
57/80