Quick Start Guide; Factory Default Settings - Num'axes SL1008 Guide D'utilisation

•
recording time during setting or quantity of captured
image/video.

Quick Start Guide

This guide is designed to get you up and running in a matter of
moments. To get the most out of the camera, please read the
manual thoroughly before operating.

Factory Default Settings

Time Out: 30 Seconds
Burst Mode: 3 Still Images per trigger (3P)
Photo resolution: 3M
Operation Mode: PIR
Video Mode: video length 10 Seconds - resolution 720P
Time lapse Mode setting: time frame 19:00 to 07:00 the next
day, Time out 60 Seconds, Resolution 12M, 1 Still Image per
trigger (1P).
Initial Camera Set-up – Time and date setting
1. Insert an SD card into the camera.
2. Press the battery tray releaser and slide out the battery
tray. Install 8 "AA" batteries into the tray with correct
polarity (+/-) as indicated, and then push the battery tray
into the camera.
3. Slide the switch from OFF to SET to adjust the Time and
Date.
4. The status display shows "T" in blinking.
: It indicates the date/time/time out and video
49/80