Num'axes SL1008 Guide D'utilisation page 56

•
The word "PIR" will be blinking, press [OK] to confirm the
camera's operation is PIR detection.
•
Press the [UP] or [DN] button until the word "CAM" is
blinking.
•
Press [OK] once to confirm camera into CAM mode.
•
Press the [UP] button once to enter burst shoot setting,
the word "burst" will be blinking.
•
Press [OK] then press the [UP] or [DN] button to select
the desired burst mode setting (from 1P to 10P).
•
Press [OK] to save your selection, then the time out "T-O"
will be blinking. Press the [OK] button to enter the time
out setting or the [M] button to exit.
Setting the Video Resolution in PIR mode
Your camera can be programmed to 2 different video resolutions:
2 Stars is HD 1280 x 720 pixels, 1 Star is VGA 640 x 480 pixels.
•
Slide the switch to the SET position, the status display will
show the camera current status.
•
Press the [M] button once to enter the Manual
programming mode.
•
The word "PIR" will be blinking, press [OK] to confirm the
camera's operation is PIR detection.
•
Press the [UP] or [DN] button until the word "VIDEO" is
blinking.
•
Press [OK] once to confirm the camera in VIDEO mode,
the word "RES" will be blinking.
56/80