User Maintenance - BaByliss PRO RAPIDO BAB7000IE Mode D'emploi

CONCENTRATOR NOZZLES
The RAPIDO hair dryer comes with 3
different concentrator nozzles:
- one 6mm x 60mm straight,
narrow nozzle that is perfect for
straightening because it lets you
achieve the required tension on
the hair.
- one 6mm x 75mm beveled, large
nozzle for smoother blow-drying;
it is slightly diagonal in shape,
hugging the shape of the brush
perfectly.
- one 4mm x 70mm ultra-thin
nozzle for optimal, controlled
air pressure and even more
efficiency.
WARNING
The 4 mm concentrator nozzle was
exclusively designed to be used
with the RAPIDO hair dryers. For
safety reason please do not use it
with any other hair dryer.
It may damage the appliance and
be dangerous to the user.

USER MAINTENANCE

The dryer must be kept clean for
proper operating performance.
When cleaning is needed, unplug
the cord, allow to cool and clean
dust and lint from air intake open-
ings with a small brush or the
brush attachment of a vacuum
cleaner. The outer surface of the
dryer should be wiped clean with
a cloth only. Blocked or clogged air
intake vents will cause the dryer to
overheat. If overheating occurs, an
automatic safety device will shut
the dryer or the heat off to prevent
damage or personal injury. If the
unit or the heat cycles off, turn the
dryer off, unplug the cord, and al-
low the dryer to cool for 10 to 15
minutes before restarting. Make
sure air vents are clean, by follow-
ing the steps below.
1. Remove intake filter from back of
dryer by twisting counterclockwise.
2. Reach through opening, and
press the mesh screen to release
it from the filter (Fig. 1).
3. Visually inspect the filter to
make sure no hair is caught (Fig.
2). Rinse the mesh screen ONLY
under running water to clear any
debris. Repeat as needed, or use
a stiff bristle brush for any diffi-
cult buildup.
4. Make sure the mesh screen is free
from any debris and completely
dry. Place screen into bottom
part of removable intake filter
(Fig. 3).
5. Press with your finger around the
edge of the screen to lock mesh
screen in place (Fig. 4).
9