User Maintenance - BaByliss PRO STELLATO DIGITAL 4Artists Mode D'emploi

creased during drying and gener-
ates static electricity, which causes
the scales of the hair to move away
from each other. The surface of hair
thus becomes rough and takes on
a lifeless appearance. The negative
ions generated by this hair dryer
will neutralize the positive charge
and, in this way, remove any static
electricity in the hair. Hair is shiny
and easy to style. It has been prov-
en that ionic technology acts as a
catalyst for hair products.
LIGHTWEIGHT AND ERGONOMIC
The STELLATO DIGITAL hair dryer
has an ergonomic handle that
makes it very comfortable to use.
Its light weight and ideal balance
make it perfect for the salon.
CONCENTRATOR NOZZLES
The STELLATO DIGITAL hair dryer
comes with 3 different concentrator
nozzles:
- one 6mm x 60mm straight,
narrow nozzle that is perfect for
straightening because it lets you
achieve the required tension on
the hair.
- an ultra thin and dual concentrator
nozzle for even greater air flow
optimization.
- one 4mm x 70mm ultra-thin
nozzle for optimal, controlled
air pressure and even more
efficiency.
WARNING
The 4 mm and the dual concentrator
nozzles were exclusively designed
to be used with the STELLATO
DIGITAL hair dryer. For safety
reason please do not use them with
any other hair dryer. It may damage
the appliance and be dangerous to
the user.

USER MAINTENANCE

The dryer must be kept clean for
proper operating performance.
When cleaning is needed, unplug
the cord, allow to cool and clean
dust and lint from air intake open-
ings with a small brush or the
brush attachment of a vacuum
cleaner. The outer surface of the
dryer should be wiped clean with
a cloth only. Blocked or clogged air
intake vents will cause the dryer to
overheat. If overheating occurs, an
automatic safety device will shut
the dryer or the heat off to prevent
damage or personal injury. If the
unit or the heat cycles off, turn the
dryer off, unplug the cord, and al-
low the dryer to cool for 10 to 15
minutes before restarting. Make
sure air vents are clean, by follow-
ing the steps below.
1. Remove intake filter from back of
dryer by twisting counterclockwise.
2. Reach through opening, and
press the mesh screen to release
it from the filter (Fig. 1).
3. Visually inspect the filter to
make sure no hair is caught (Fig.
2). Rinse the mesh screen ONLY
under running water to clear any
debris. Repeat as needed, or use
a stiff bristle brush for any diffi-
cult buildup.
4. Make sure the mesh screen is free
from any debris and completely
9