Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch LR 2 Professional Notice Originale

OBJ_BUCH-821-003.book Page 18 Thursday, December 20, 2012 12:37 PM
18 | English
Working Advice
Marking
When the laser beam runs through the center of the reception area 10, its height can
be marked at the centre mark 8 right and left on the measuring tool.
When marking, take care to align the measuring tool exactly vertical (for horizontal
laser beam), or horizontal (for vertical laser beam), as otherwise the marks are offset
with respect to the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the measuring tool can be
attached to steel parts via the face side using the magnet plate 5.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any cleaning agents or sol-
vents.
If the measuring tool should fail despite the care taken in manufacturing and testing
procedures, repair should be carried out by an authorised after-sales service centre
for Bosch power tools. Do not open the measuring tool yourself.
In all correspondence and spare parts orders, please always include the 10-digit
article number given on the type plate of the measuring tool.

After-sales Service and Application Service

Our after-sales service responds to your questions concerning maintenance and
repair of your product as well as spare parts. Exploded views and information on
spare parts can also be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning our prod-
ucts and their accessories.
1 609 92A 05F | (20.12.12) Bosch Power Tools