Troubleshooting - Yamaha CD-S2000 Mode D'emploi

Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or
if the instructions below do not help, turn off this unit, disconnect the AC power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem
The unit does not
The power cord is not connected nor completely
switch ON when connected.
POWER is pressed
upward.
The disc tray does not A foreign object is obstructing the tray.
close completely.
Playback does not The disc is damaged.
start.
There is moisture on the laser pickup.
The disc is loaded upside down.
The disc is dirty.
The MP3 or WMA formats are not compatible
with this unit.
The CD-RW (ReWritable) disc is not recorded
correctly.
The disc is a non-standard disc not playable with
this unit.
Playback is delayed,
The disc may be scratched or damaged.
or begins at the
wrong place.
No sound. Improper output cable connections.
Improper amplifier operation.
Sound "skips".
This unit is being subjected to vibrations or
impacts.
The disc is dirty.
Sound "hums".
Improper cable connections.
Noise from a nearby
The tuner is too close to this unit.
tuner.
Noise from inside of The disc may be warped.
the disc tray.
The remote control The batteries of the remote control are too weak.
does not work.
Remote control is too far away or tilted too
much.
Direct sunlight or lighting (of an inverter type
fluorescent lamp etc.) is striking the remote
control sensor of this unit.
Cause
Securely connect the power cord.
Carefully check the disc tray and remove the
foreign object.
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after switching the unit
ON before trying to play back a disc.
Reload the disc with the label side up.
Clean the disc.
Replace the disc with a correctly recorded disc
playable with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
Check the disc carefully; replace it if necessary.
Connect the cables properly. If the problem
persists, the cables may be defective.
Set the amplifier controls to the correct input
selection.
Relocate this unit.
Clean the disc.
Securely connect the audio cables. If the problem
persists, the cables may be defective.
Move the tuner and this unit farther apart.
Replace the disc.
Replace the batteries with new ones.
Use within 6 m and 60° radius.
Reposition this unit.

Troubleshooting

Remedy
See
page
16
—
—
—
—
—
20
—
—
—
14
—
—
—
14
—
—
12
12
12
21
En