Additional Information; Troubleshooting; General; Ipod - Yamaha TSX-120 Mode D'emploi

ADDITIONAL INFORMATION

In case of a problem with the unit, check the following list first. If you cannot solve your problem with the suggested
solutions or if your problem is not listed below, turn off and unplug the unit, and consult the nearest authorized Yamaha
dealer or service center.

General

Problem
The system turns on but
immediately shuts off.
The speakers make no
sound.
Sound suddenly turns off.
The unit does not operate
properly.
A digital or high-frequency
equipment produces noises.
The clock setting has been
cleared.

iPod™

Problem
"iPod Connect Error"
appears on the front panel
display.
The iPod does not charge
up.
"iPod Not Connected"
appears on the front panel
display after you set the
iPod.
The iPod makes no sound.
The iPod sounds, but you
cannot operate it with the
unit or the remote control.

TROUBLESHOOTING

Cause
The power cable may be connected
improperly.
The unit may have received a strong
electrical shock such as lightning or
excessive static electricity.
The volume may be set to the
minimum level.
The mute function may be on.
The source may be incorrect.
The sleep timer (☞ P. 8) may be set.
The unit may have received a strong
electrical shock such as lightning or
excessive static electricity, or power
supply may have dropped.
The unit may be placed too close to
the digital or high-frequency
equipment.
The unit is left more than one week
after you disconnect the power cable
from the wall outlet.
Cause
There is a problem with
communication between the unit and
your iPod.
The iPod is set in the iPod dock
improperly.
Solution
Make sure the power cable is plugged
into the wall outlet firmly.
Set the system to off, and disconnect
the power cable. Wait about 30
seconds, reconnect the power cable, and
turn on the system.
Adjust the volume level (☞ P. 9).
Cancel the mute function (☞ P. 9).
Select the correct source (☞ P. 9).
Turn on the system and play the source
again.
Set the system to off, and disconnect
the power cable. Wait about 30
seconds, reconnect the power cable, and
turn on the system.
Place the unit farther away from the
equipment.
Plug the power cable into the wall
outlet firmly, and set the clock again
(☞ P. 4).
Solution
Turn off the system and reconnect your
iPod to the unit.
Remove the iPod from the unit, then set
it in the iPod dock again.
15
En