Pairing The Wireless Switch Adapter With The Brematicpro Gateway; Factory Reset; Cleaning The Device; Troubleshooting - brennenstuhl BRENN_1294510 Mode D'emploi

Pairing the Wireless Switch Adapter with the
BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app / BrematicPRO PC
software to use additional functions, e.g. timer control, theme control,
astro function (dawn / dusk control).
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the gateway.
Open the "Settings" menu.
Select the room where you wish to use the device.
Select "Add Device".
Select the frequency "868 MHz".
Under "New Device", select "Switch / Socket" and click "Continue"
to confirm your selection.
Follow the on-screen instructions.
Press and hold the Pair button on the device for 3 seconds.
Enter a device name for the wireless switch adapter, e.g. "Living
Room Floor Lamp".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete the
pairing process.
The wireless switch adapter is now connected to the Home
Automation Systems BrematicPRO.
Use "Test Device" to switch the device on and off to ensure the
wireless switch adapter is working properly.
In this submenu you can also add the device to your favourites.
For more information about the app and how to use it, please visit:
www.brematic.com/en/service

Factory reset

The device can be restored to the factory settings at any time. A reset
will be required if malfunctions occur.
Press the Pair button for at least 6 seconds.
The LED will flash rapidly and go out after approx. 3 seconds.
The device has been reset.

Cleaning the device

DANGER! RISK OF ELECTRIC SHOCK!
Disconnect the device from the mains before cleaning.
Do not allow liquids to enter the device. Liquids entering can result in
a short circuit.
Wireless Switch Adapter with Energy Measurement 868.3 MHz
Clean the device with a dry, lint-free cloth. For tough dirt, you
may also slightly dampen the cloth.
Do not clean with solvent-based cleaners. These could damage
the product surface and markings.
Never immerse the device in water or other liquids. The device
may otherwise be damaged.
Be sure the device is completely dry before using it again.

Troubleshooting

Problem
LED doesn't flash.
Device not
detected.

Disposal

The packaging is made from environmentally-friendly
materials which can be disposed of through your local
recycling facilities.
Contact your municipality for more details on how to dispose of your
worn-out product.
To help protect the environment, please dispose of the
product properly when it has reached the end of its
useful life, not in the household waste. Please contact
your municipality for information on collection facilities
and their opening hours.

Service

For information about the product, please contact us at
www.brematic.com/en/service.
Tel.: 0080048720743 (toll-free)
Possible cause Action
The device is not Connect the device to
properly connected the socket properly.
to the socket. Verify the wall
socket is powered.
The device is Reduce the distance
outside the to the gateway.
gateway range.
EN 13