Bosch PSR 10,8 LI Notice Originale page 25

OBJ_BUCH-1400-002.book Page 25 Wednesday, July 4, 2012 7:49 AM
Service
Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of
the power tool is maintained.
Safety Warnings for Drills and Screwdriver
Hold power tool by insulated gripping surfaces, when performing
an operation where the cutting accessory or fastener may contact
hidden wiring. Cutting accessory and fasteners contacting a "live"
wire may make exposed metal parts of the power tool "live" and could
give the operator an electric shock.
Use appropriate detectors to determine if utility lines are hidden
in the work area or call the local utility company for assistance.
Contact with electric lines can lead to fire and electric shock. Damaging
a gas line can lead to explosion. Penetrating a water line causes prop-
erty damage.
Switch off the power tool immediately when the tool insert jams.
Be prepared for high reaction torque that can cause kickback. The
tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
Hold the machine with a firm grip. High reaction torque can briefly
occur while driving in and loosening screws.
Secure the workpiece. A workpiece clamped with clamping devices
or in a vice is held more secure than by hand.
Always wait until the machine has come to a complete stop before
placing it down. The tool insert can jam and lead to loss of control over
the power tool.
Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational di-
rection switch to the centre position. Unintentional actuation of the
On/Off switch can lead to injuries.
Do not open the battery. Danger of short-circuiting.
Protect the power tool against heat, e. g., against continu-
ous intense sunlight, fire, water, and moisture. Danger of
explosion.
Bosch Power Tools
English | 25
2 609 005 103 | (4.7.12)