Eaton MGR10 Serie Manuel D'utilisation page 66

These commands allow the measurement configuration to be set up, but they do not trigger a
measurement.
SENSe:FRESistance:RANGe <range>
Sets the resistance measurement according to the following parameters. The current
measurement is aborted.
MGR10 et MGR10A:
<range>
MGR10B:
<range>
MGR10C:
<range>
AUTO1 and AUTO2 are not available in FAST mode, nor if Open Circuit Limiting is
enabled. The 3KOHM and 30KOHM ranges are also not available if Open Circuit Limiting
is enabled.
Sending these commands in these conditions will generate an "execution error". The
command will be ignored and the microhmmeter will remain in the original range.
SENSe:FRESistance:RANGe?
3MOHM
30MOHM
200MOHM
3OHM
30OHM
300OHM
3KOHM
30KOHM
AUTO1
AUTO2
300MOHM
3OHM
30OHM
300OHM
3KOHM
30KOHM
AUTO1
AUTO2
3OHM
30OHM
300OHM
3KOHM
30KOHM
AUTO1
AUTO2
MGR10 A/B/C Indice : J (version 7.0 du logiciel)
(3 mOhm)
(30 mOhm)
(200 mOhm)
(3 Ohm)
(30 Ohm)
(300 Ohm)
(3 KOhm)
(30 KOhm)
(Autorange1 - top range first)
(Autorange2 - last-used range first)
(300 mOhm)
(3 Ohm)
(30 Ohm)
(300 Ohm)
(3 KOhm)
(30 KOhm)
(Autorange1 - top range first)
(Autorange2 - last-used range first)
(3 Ohm)
(30 Ohm)
(300 Ohm)
(3 KOhm)
(30 KOhm)
(Autorange1 - top range first)
(Autorange2 - last-used range first)
66