Thread the wire carefully inside the frame tube.
2.
Push the handlebar support tube into place inside the
frame tube, so that the fastening screws are on the right
side of the tube. Be careful not to damage the meter
wire!
3.
Use the enclosed Allen key to tighten both fastening
screws through the holes in the tube.
the fastening screws by turning them counter-clockwise.
And not too tight!
4.
Finally, place the decorative plastic cover over the
joint.
INTERFACE
1.
Connect the cable from the handlebar support tube
to the interface connector.
2.
Handgrip pulse version: connect the cable from the
handlebar tube to the interface cable.
3.
Push the interface carefully into place at the top of the
handlebar support tube.
4.
Lean the frame carefully backwards so that it rests on
the rear support and seat.
5.
Make sure that the moduleis correctly in place and
tighten the two fastening screws.
4
REAR SUPPORT
Fasten the rear support from beneath with two more hex
screws and washers.
FRONT SUPPORT
NOTE!
Tighten
Fasten the front support firmly into place with the 4
screws and washers provided.
Lift the device back into the upright position.
PEDALS
The pedals are distinguished by the markings L (left)
and R (right) on their shaft. Fasten the left pedal to
the left pedal-crank by turning it counter-clockwise,
and the right pedal to the right pedal-crank by turning
it clockwise. Select strap tightness, set the appropriate
strap hole on the retainer from below and pull forcibly
upward. Especially when the equipment is new, the
strap fastening may seem relatively tight.
E85 / E85S: POWER CORD
Plug the socket end of the transformer cord into the
connector, just above the rear support in the centre of
the frame, and the other end into the wall socket. To
prevent damage to the cord, we recommend you tie it to
the protector next to the connector.