Table des Matières
Publicité
Weight and Dimensions are approximate. Because we continually strive to improve our products we may change
specifications and designs without prior notice.
Installation
Selection of installation equipment
1. Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface material to avoid
larger deformation caused by the heat radiation from the hotplate. As shown below:
A
B
268＋4
500＋4
- 0 mm
2. The ceramic cooker hob can be used on the table top of cabinet. The ceramic hob should be placed horizontally. As
shown below:
A
B
50mm mini
50mm mini
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet and outlet are not blocked.
Ensure the ceramic cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least 760mm.
C
50mm mini
-0 mm
D
E
50mm mini
50mm mini
EN-11
F
50mm mini
Publicité
Table des Matières
