NORAUTO ESSENTIAL Mode D'emploi page 131

Connecting the charger and charging the Battery with the Terminal Rings
IMPORTANT: Before start connecting, unplug the battery Charger AC cord from the AC
outlet. Disconnect the battery clamps from the unit at output cord connector.
The charger's battery eyelets are color-coded (RED-POSITIVE and BLACK-NEGATIVE).
NUT
CONNECTOR
1. Remove the nuts from the bolts of the battery post's
connectors.
2. Position the red terminal ring on the bolt of the
positive battery post connector.
3. Position the black terminal ring on the negative
battery post connector; then replace the nuts.
Connect the battery eyelet connector to the unit
connector, as far away from the battery as possible.
1
TERMINAL
RING
BOLT
2
Plug the unit to the power socket.
* The charger remains in Float Charge Mode as
long as the charger is connected to the battery
and is plugged into a functioning AC mains
socket.
To Start the Charging
Press CHARGER button, to select the charging
voltage mode (6V or 12V) according to the battery
voltage.
Attention: Please wait for few seconds to toggle the
6V or 12V charging mode by pressing the button.
131
3
4