NORAUTO ESSENTIAL Mode D'emploi page 125

- Do not let the red and black clamps touch each other, as it may
lead to sparks, explosion and cause damages.
- Before making any electrical connection, check that:
4The appliance and its components are not damaged. In which
case, do not use the appliance but bring it back to your reseller for
inspection and fixing.
4The indicated voltage on the rating label matches with your
electrical installations.
- Position the battery charger as far away from the battery as the
leads will allow.
- Explosive gases may collect near the ground. Locate the battery
charger as high as possible above ground level.
- Do not proceed to any maintenance operation by yourself. Any
check, disassembling or fixing has to be performed exclusively by
a qualified person.
- Do not open body casing. There are no user-serviceable parts inside.
- Do not place the battery charger above or stand the battery
charger on top of the battery.
- The battery terminal not connected to the chassis has to be
connected first. The other connection is to be made to the chassis,
remote from the battery and fuel line. The battery charger is then to
be connected to the supply mains. After charging, disconnect the
battery charger from the supply mains. Then remove the chassis
connection and then the battery connection.
SAFETY INSTRUCTIONS REGARDING BATTERIES
- WARNING: Risk of explosive gas mixtures. Working in the vicinity
of a lead-acid battery is dangerous. Batteries generate explosive
gases during normal battery operation. For this reason, it is of
utmost importance that each time, before using your battery
charger, you read this manual and follow the instructions exactly.
- Thanks to check that your batteries can be recharged with this
charger. To know this, refer to the manufacturer's instruction
manual of the battery.
- Make sure that the initial charging rate does not exceed the battery
manufacturer's requirement.
125