EHEIM streamON+ 2000 Mode D'emploi page 17

Using light pressure and by making a rotating motion, insert the damping
buffer into the two lower and upper openings of the pump holder.
Connect the pump holder to the magnetic holder designed for the inside
of the aquarium (Fig. B
Now, position the pump holder with the magnet in the desired spot in
the aquarium and lock into position with the magnetic holder from the
outside (Fig. B
below the water (Fig. B
C Putting into operation
Place the streaming pump into the aquarium in such a way that it will
not cause any damage if it accidentally falls off.
So that the pump does not draw-in any air, it should be mounted
approximately 10 cm below the surface of the water. Set the desired
direction of flow by rotating sideways to the left or right when holding
plate is positioned vertically (Fig. C
backwards or forwards if the pump holder is positioned horizontally (Fig.
C and C ).
3 4
By shifting the output regulator b within the –min. and +max. range
(shift by lightly pressing on both sides of the output regulator), the flow
rate can be adjusted as required (Fig. C
Switch on using the mains plug. (EU: 230 V / 50Hz | US : 120 V / 60Hz)
D Care and Cleaning
Unplug the mains plug and make sure that the pump is de-energized. To
remove the pump, gently press the tab on the pump holder away from
the pump and remove the pump by tilting it backwards out of the holder
(Fig. D ). Use a brush or a sponge to clean away coarse dirt from the
1
pump basket. Remove any blockages from the flow opening if they are
clogged.
Remove the pump basket by gently pressing the sides of the latch hooks
forwards away from the motor body (Fig. D
pull the pump wheel forwards away from the full-floating axle ( bb. D
With the streamO + 4000 and 5000, the axles are at the front centre of
the pump basket and at the rear centre of the pump casing and both hou-
).
1
). Click the EHEIM streaming pump into the pump holder
2
).
3
and C ) or by inclining the pump
1 2
/ C ).
5 6
) With the streamO + 2000
2
).
3