Items Supplied; How To Use; Operation; Heating Up - SilverCrest SKG 1700 A2 Mode D'emploi

4. Items supplied

1 Contact grill with two grill plates
2 Grease drip trays
1 Set of operating instructions

5. How to use

DANGER! Risk of fire!
Place the device on a dry, level, non-slip
and heat-resistant surface.
The device must not be operated close
to flammable liquids or materials, or in
a potentially explosive environment.
Keep at a distance of at least 30 cm
from walls.
NOTE: when in operation for the first time,
some smoke and odour may be generated
by the device. This is related to materials
used on the heating elements during assem-
bly, and is not a defect with the product. En-
sure adequate ventilation.
• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use! (see "Cleaning" on page 52)
1. Open the lid 4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
2. Before plugging in the device, check
that both thermostat controls 9 + 15
are set to the marking "•".
3. Insert the mains plug 6 into a wall sock-
et corresponding to the specifications of
the rating plate. The power indica-
tor 10 is illuminated as long as the de-
vice is connected to the power supply.
4. Rotate the thermostat controls 9 + 15 to
temperature setting 5. The device then
heats up the grill plates 13, and the con-
trol lights 1 and 12 are illuminated.
50 GB
5. Switch the device off after approx.
15 minutes by turning both thermostat
controls 9 + 15 to the marking "•".
6. Clean the appliance again. (see
"Cleaning" on page 52)

6. Operation

DANGER! Risk of injury
through burning!
The metal surfaces become very hot dur-
ing operation. Only touch the handles
and control elements of the device dur-
ing operation.

6.1 Heating up

1. Open the lid 4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
2. Grease the grill plates 13 with vegeta-
ble oil or butter if appropriate.
3. Place a grease drip tray 16 under the
oil/fat runoff of the bottom grill plate 8.
4. Close the lid 4 downwards in order to
close the contact grill.
5. Before plugging in the device, check
that both thermostat controls 9 + 15
are set to the marking "•".
6. Insert the mains plug 6 into a wall sock-
et corresponding to the specifications of
the rating plate.
7. Turn the thermostat controls 9 + 15 to
the desired temperature setting 1, 2, 3, 4
or 5.
- Setting 1: thaw
- Setting 2: warm
- Settings 3 and 4: moderate grill set-
tings
- Setting 5: highest grill setting
The device then heats up the grill
plates 13, and the control lights 1 and 12
are illuminated.