General Guidelines; General Operation; Mounting Bracket - Perel EWL515 Mode D'emploi

•
Do not remove the cover under any conditions. There are no user-serviceable parts
inside. Never operate this device when its cover is removed.
•
Do not operate a visibly damaged device. Do not attempt to operate this device if
the power cord has been frayed or broken.
•
Always mount this device in a safe and stable manner. Mount this device in an area
that will allow proper ventilation. Allow about 15 cm between this device and a wall.
•
This device should only be serviced by qualified service personnel.
•
Do not use the luminaire with a cracked or broken protective shield. Disconnect
immediately from the mains. The protective shield is not replaceable.
•
Familiarise yourself with the functions of the device before actually using it.
•
Always make sure to connect the device to an alternating current matching the
value stated on the device.
•
Always install the device in a well-ventilated location.
•
In the event of an operating problem, stop using the device immediately.
•
Never try to repair the device. There are no user-serviceable parts inside the device.
Refer to an authorized dealer for service and/or spare parts.
3.

General Guidelines

•
Refer to the Velleman
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Operation

General Operation

1. Place the work light on a flat, stable and non-slippery surface.
2. Insert the power plug into the mains to switch on the appliance.
3. Switch off after use by pulling the plug from the mains.

Mounting Bracket

1. Slightly loosen the fixing knob.
2. Adjust the angle as desired.
3. Re-tighten the fixing knob.
V. 03 – 13/09/2019
EWL515
® Service and Quality Warranty on the last pages of this
3 ©Velleman nv