Cembre HT120 Notice D'utilisation Et Entretien page 5

– Lower die (90)
Take the die off its guide by pushing the die/ram release pin (31).
To facilitate this operation an advancement of 3÷4 mm of the ram (22) is suggested.
Insert the new die in its guide until secured by the die/ram retaining pin (33).
30
27
33
4. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool.
4.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove any residual,
especially close to pivots and moveable parts.
4.2) Storage
(Ref. to Fig. 5)
When not in use, the tool should be stored and transported in the plastic case, to prevent damage.
Plastic case: type VAL P3; dimensions 620x380x135 mm; weight 2,5 kg.
5
25
22
91
31
FIG. 2 DIE REPLACEMENT
ENGLISH
90