Horizon Fitness EX-68 Manuel Du Propriétaire page 12

ASSEMBLY Step 3
eX-78 SHoWn
all
MoDelS
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
12
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
MAIN FRAME
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
gently slide the console mast onto the
C
main frame and attach console mast to
main frame using pre-installed bolts.
Slide wavy washer (l) over crank
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the crank using 1
E
flat washer (k), 1 spring washer (b)
and 1 bolt (m).
WAVY WASHER (L)
FLAT WASHER (K)
Repeat steps E–F on the opposite side of the
F
SPRING WASHER (B)
elliptical.
BOLT (M)
HarDWare BaG 3 CONTENTS :
WAVY WASHER (L) BOLT (M) SPRING WASHER (B)
22.5 mm 20 mm 15 mm
Qty: 2 Qty: 2 Qty: 2
FLAT WASHER (K)
20 mm
Qty: 2