LaserLiner ClampMeter XP Mode D'emploi page 24

Function overview
18
The function described under point 13 to 17 are available in the measurement variable shown below:
Current measurement AC (1000 A)
Current measurement DC (1000 A)
Current measurement AC (500 A)
Current measurement DC (500 A)
Contact temperature measurement
Frequency measurement
Duty factor measurement
Capacitance measurement
Resistance measurement
Diode test
Continuity test
Voltage measurement AC
Voltage measurement DC
Hold function
19
The „Hold" function enables you to keep the current measured value on the display.
Press the „HOLD" (13) button to activate and deactivate the function.
Auto range
20
The „Auto range" function is activated automatically when the meter is switched on. Auto range
searches for the best possible range for each measurement in the corresponding measuring functions.
Backlight
21
Long-press the button (13) to switch the backlighting on and off.
Flashlight function
22
Short-press the button (3) to switch the flashlight on and off.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents, scouring agents and solvents.
Remove the battery(ies) before storing for longer periods. Store the device in a clean and dry place.
Calibration
The meter needs to be calibrated and tested on a regular basis to ensure it produces accurate
measurement results. We recommend carrying out calibration once a year.
24
EN
• • • •
/ / /
•
– / – / – / –
• • • •
/ / /
•
– / – / – / –
•
– / – / – / –
•
– / – / – / –
•
– / – / – / –
– / – – / – / –
•
– / – / – / –
•
– / – / – / –
•
– / – / – / –
• • •
/ – / /
•
– / – / – / –
• •
•
• •
•
•
–
–
–
–
–
–
• •
•