Outdoor Unit (Doorbell) - Byron DIC-24615 Mode D'emploi

Instruction manual
2. Power on/off
3. Menu / OK button
4. Scroll key forward / snapshot / video
5. Scroll key back
6. Power / Charge indicator
7. Monitor / Intercom button
8. Door opener
9. Gate opener
10. Microphone
11. Micro SD card slot
12. Power indicator
13. AC adapter

2.2.2 Outdoor unit (doorbell)

1. Microphone
2. Night sensor
3. Outdoor camera
4. Name plate
5. Call button
6. External antenna plugin
7. Reset button
8. Power switch
9. Antenna switch
3 Installation
4
Make sure pin 1 at the back of the outdoor unit is switched to 'power
on'.
3.1 PLACING THE INDOOR UNIT (MONITOR)
The indoor unit (monitor) is designed to be portable.
A. Place the charging dock on a flat, stable surface near a wall outlet.
B. Plug in the adapter on the back of the charging dock.
C. Place the indoor unit on the charging dock.
3.2 MOUNT THE OUTDOOR UNIT
(DOORBELL)
To mount the outdoor unit, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Use a knife or sharp object to puncture the cable gland. (Optional,
only when installing the AC Power. Cables are not included.)
F. Pull the required cables through the cable gland. (Optional, only
when installing the AC Power. Cables are not included.)
G. Fasten the mounting plate with the screws.
H. Remove the front cover of the outdoor unit by removing the screw
at the bottom.
I. Attach the outdoor unit to the mounting plate.
J. Fasten the outdoor unit with the supplied screws.