Brightness Control; Setting; Autonomous; Afnor Nfs 87500 Code Receiver - Gorgy Timing LEDI 1S Mode D'emploi

the brightness is adjusted by pressing on the "+" and "-" button.
the button can be reached through the holes in the front of the unit, using a small screwdriver

4.1. aUtOnOMOUS

the time is set by using the "+","-" and "proG" buttons on the front of the unit.
Each time the "PROG" button is used, a different part of the display begins to flash. This is
then modified by using the "+" and "-" buttons.
the setting cycle is as follows:
► Hour, minute, second display: adjustment of hours
► Hour, minute, second display: adjustment of minutes
► Hour, minute, second display: synchronisation
► Hour, minute, second display: time base

4.2. aFnOR nFS 87500 CODE RECEIVER

the code is getting at right time when the code is connected on the «CoDE» connector.

4.3. SMPtE / EBU RECEIVER CODE

Clock used to read the time code SMptE or EBU delivered at standard speed.
► Connect the code to the input terminal
► Automatic adaptation to SMptE or EBU format
► Automatic selection at the rate of 24.25 or 30 images a second
► Maximum error tolerance for the rate of code received : +/- 10%
► Display freezes on last frame received if the signal emitter stops functioning
MDE-LEDI1S-2S-1066V1.0
3.

BRIGHtnESS COntROL

4.

SEttInG

21