Elem Garden Technic MTBE302T Traduction Des Instructions D'origine page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Assembly
(fig. 1-17)
Connect the bar
Connect the directional bar with nuts and screws
supplied in the package.
Do not plug the unit into the
socket until it is completely
Only use original spare parts,
fault what, operation and safety
would not guaranteed.
V Make sure all nuts, bolts and screws are firmly
tightened to ensure safe operating conditions.
Storing Your Electric Hoe
_ Connect the device to an appropriate extension.
_ Attach the extension behind the terminal.
_ Hold the camera with both hands.
_ Press the electrical isolation switch (8) and snap
the lever (9). The engine will start and the teeth
begin to rotate.
_ To stop the machine, release the lever
Risk of injury if Electric Hoe
V Do not remove or bridge the
installed on the Electric Hoe
(e.g. by fastening down the
Electric Hoe blades will con-
Atinue to run for a short time
V Never lift or carry the Electric
Hoe while the motor is running.
V When starting the Electric
Hoe make sure that your feet
are at a safe distance from the
Working position: Always guide
the Electric Hoe by the
handle(s) using both hands
V Guide the Electric Hoe at
assembled.
Caution!
Wear work gloves!
does not switch off
automatically.
safety devices
button/ lever to
the handle).
Warning!
after the hoe has
been turned of:
hoe blades.
Warning!
(see Fig.).
walking pace only.
Tips for proper working
Place the machine in front of the area you wish to
hoe and hold it securely on the push bar before you
switch on the machine. Guide the hoe blades over
the area.
To achieve cleanly hoed soil always ensure that you
guide the machine in straight lines wherever
possible. Insodoing, the aeration swaths should
always overlap each other by a few centimeters in
order to avoid bare strips.
Switch off the motor promptly when you arrive at the
end of the area you wished to hoe. The motor must
be switched off when you raise the machine (for
example to change direction).
Keep the underside of the machine clean and
remove soil deposits. Deposits make it more difficult
to start the machine and decrease the working
depth.
Work perpendicular to the slop on inclined areas.
The machine must be switched off and the mains
cable disconnected before you make any checks on
the hoe blades.
Important!
The hoe blades will continue to rotate for a few
seconds after the motor is switched off. Never
attempt to manually stop them. In the event that the
rotating hoe blade strikes an object, immediately
switch off the machine and wait for the hoe blades
to come to a complete stop. Then inspect the
condition of the hoe blades. Replace any parts that
are damaged.
Lay the power cable on the ground in front of the
outlet in a figure 8. Work away from the outlet or
cable and ensure that the power cable always trails
in the hoed soil which will prevent the hoe blades
from traveling over the cable.
20

Publicité

Table des Matières
loading

Table des Matières