General Instructions - T&S B-0580 Instructions D'installation Et D'entretien

General Instructions

Nozzle Installation:
1. Shut off water supply and drain
lines. Existing supply lines should be
roughed into wall or sink back-
splash. Use 1/2" IPS (Iron Pipe Size)
inlets (male for B-0580, female for
B-0585) supplied by others.
2. Loosen no.10 on assembly.
Remove no.4 assembly from no.2 or
no.3.
4
10
3
2
1
Model B-0585
wall or
back-splash
3. Tighten no.1 towards no.2 as far as
it will go by hand.
4. Apply teflon tape to threads of inlet
pipe. Screw no.2 (B-0580) into inlet
pipe as far as it will go, tighten with a
wrench.
5. Tighten no.1 so that it is flush
against wall.
6. Replace no.4 assembly into no.2
(B-0580) or no.3 (B-0585), tighten
no.10 firmly against no.2 or no.3.
For swivel repair or replacement of
(o-ring) no.6 and (sleeves) no.7:
1. Shut off water supply and drain
lines.
2. Loosen no.10 on assembly. Remove
no.4 assembly from no.2 or no.3.
3. Insert one no.7 onto no.8. Install
no.6 on no.8 and lubricate liberally
with o-ring grease. Install second
no.7 onto no.8. (See Enlarged View)
8
12
7
Outlet Assembly:
For repair or replacement of parts:
1. Insert prongs of no.17 through
hole in part no.18 and flair outward,
as shown:
17
18
19
21
2. Slide no.18 through no.19 and
no.19 through no.20.
3. Insert no.21 into no.20 and tighten
firmly and securely against no.19.
6
prongs
17
20