Barcode Management; Fine Tuning Of The Table Position - Cassese MACH 5 Mode D'emploi

USER MANUAL
Keypad configuration:
When recording an
article file, a keypad
can be used to enter
the reference. If you
don't need
alphanumeric
references it is
possible to get only
a simple numeric
keypad. Press
KEYBOARD
ALFANUM button
to configure it.
6.B.k
If you are using a barcode reader, you can configure the type of barcodes that the
machine will accept. It can accept barcodes from older machine such as cs486 or
cs3099 and of course barcodes that were created for a cs4008. This option is useful if
you had these machines and don't want to modify your edition software. For example
selecting the BC 486 option, will allow using the old barcodes of a CS486ultra, but the
machine will not show the accessories to be used (such as spacer bars, type of top
clamp) as the CS486 didn't have that feature.
Touch the button BC4008 and set it to the required value.
All MACH 5 CART are ready to be plugged to a barcode reader, but it is strongly recommended to buy
the scanner from Cassese to avoid compatibility issues. The barcode plug is a serial port located under
6.B.l
If the machine doesn't open the table to the proper position, it is possible to calibrate it.
Applying +1 to OFFSET 45 will increase the position of the motorized table of +1mm.
After touching that button, a code will be requested, enter 9059 at prompt. Once the
setting is done, turn off the machine to lock back the parameters.
Figure 6-35
Page 6/7: barcode management:
the control panel.
Page 7/7: fine tuning of the table position
When KEYBOARD
NUM is selected only
that simple keypad
will be displayed for
referring an article.
MACH 5 CART
Figure 6-36
Figure 6-37
Figure 6-38
39