Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
3.D
PROPER ADJUSTMENT OF MAGNETIC ADJUSTABLE ROD CLAMP
A
magnetic
adjustable
rod
clamp comes with
your machine as a
standard
feature.
It fits the crossbar
thanks
to
the
locking ring and
can be set at 1 to 7
positions.
When adjusting the vertical rod clamp, closer it is from the top of the moulding, and faster will be
the machine. The machine will not damage the moulding, even if the distance is very close. If the
distance is superior to 50mm, the wedge will not penetrate fully inside the wood.
When levelling the machine, if the machine is installed against a working table, make sure a long
Pay
attention
to
frame will not be risen up by the table, this would cause bad joining.
properly position the
magnetic
chevron
clamp: the sides of
the chevron must be
parallel
to
back
fences 1 and 2.
Now
with
quick-
change
magnetic
clamps, it is easy to
change from chevron
to a round clamp.
Simply pull down the
Z24703 to change of
clamp support.
Pull the black knob
to be able to adjust
the space between
the
vertical
and the top of the
moulding. You must
have 50mm (2") max
between the clamp
and the top of the
moulding.
Figure 3-15
Example
setting
chevron.
Figure 3-17
Figure 3-19
clamp
of
bad
of
the
MACH 5 CART
Figure 3-16
Figure 3-18
17
Publicité
Table des Matières
