Setup; Unpacking The Machine - Cassese MACH 5 Mode D'emploi

USER MANUAL

2 SETUP

2.A. UNPACKING THE MACHINE
Cutter
Flat span N.13 & N.17
Allen key N.5
Remove the 4 bolts to
free the machine
from the crate. They
are located under the
pallet.
After unpacking the
machine, install and
set the 4 feet to level
the machine. Make
sure the 4 feet are
touching the floor,
machine must be
steady.
One is located under
the screen.

When levelling the machine, if the machine is installed against a working table, make sure a long frame will
not be risen up by the table, as this would cause bad joining. Working table and machine should be levelled
together.
When levelling the machine, if the machine is installed against a working table, make sure a long frame will
not be risen up by the table, this would cause bad joining.
Bubble level
Cut both plastic strips
in order to free the
box and lift up the
wood cover with the
help of a
person.
Figure 2-1
The screen is hold in
place with 3 screws.
2 are located on top
of the screen.
Figure 2-3
The screen can be
installed on the other
side of the machine
using the same
screws.
Figure 2-5
second
3
MACH 5 CART
Figure 2-2
Figure 2-4
Figure 2-6
12