Simple Screen: Preparing The Execution; Selecting The Stapling Mode; Selecting The Speed; Resetting The Counter - Cassese MACH 5 Mode D'emploi

USER MANUAL
If the step Erreur ! Source du renvoi introuvable. is forgotten, the article won't be memorized, meaning
it can be executed but it won't be available for further use.
4.H

SIMPLE SCREEN: PREPARING THE EXECUTION

When levelling the machine, if the machine is installed against a working table, make sure a long
Once the parameters are set correctly (see chapter 4.F SIMPLE SCREEN: PROGRAMMING A PROFILE page 26), you can then
frame will not be risen up by the table, this would cause bad joining.
configure the execution.
4.H.a
Select the mode you would like to use for stapling. Press AUTO or MANU The selected
mode will turn in black background.
MANUAL MODE : this mode will require two actions to get the corner done. Pressing the
pedal will engage the front clamps to keep both mouldings together. You can then check
the joining before launching the stapling with the stapling button. Manual mode will be
selected by default at each power up of the machine.
AUTO MODE: this is the quickest mode, the machine will engage the front clamps and
staple immediately when the pedal is pressed.
4.H.b
The vertical clamp speed can be adjusted depending on the hardness of the wood.
Using that button will set the speed of the vertical clamp. Press that button to select
turtle or rabbit mode.
TURTLE MODE : this mode will select a slower speed for the vertical clamp, it is useful
for very soft moulding.
RABBIT MODE: Most of the time this mode will not cause any damage to the moulding
and can be used to save time.
4.H.c
Pressing this button will help to set the counter, a keypad will appear allowing to reset
it or to set it to a certain number.
If you set it at zero when starting production, you will see it increasing at each cycle so
you know how many cycles were joined. You can also configure it so it will decrease.
Then entering the amount to be done in this field will allow you to see the remaining
cycles to be done.
This counter can be set so it counts frames or corners.
Refer to chapter I.6.B.b Page 2/7: counter configuration (page 34) for configuration of
that counter.

Selecting the stapling mode

Selecting the speed

Resetting the counter

MACH 5 CART
Figure 4-41
Figure 4-42
Figure 4-43
29