Sony DPP-MS300 Mode D'emploi page 16

Loading the print cartridge (continued)
If ink ribbon should tear
Repair the ribbon with
transparent tape. There
should be no problem
with using the remaining
portion of the ribbon.
Before loading the print
cartridge into the printer,
turn the reel until the
transparent tape can no
longer be seen.
Repair with
transparent tape.
Notes on storing the
print cartridge
• Avoid placing the
cartridge in a location
subject to:
– high temperatures
– high humidity
– excessive dust
– direct sunlight
• When you are going to
store a partially-used
cartridge for an
extended period of
time, store it in its
original bag.
16 GB
Setting Up
To eject the print cartridge
Open the cartridge compartment lid and push up the
eject lever. Then remove the print cartridge.
Eject lever
Cartridge error indicator
To replace the print cartridge
If you try to print when the ink ribbon of the print
cartridge runs out, the print paper is automatically
loaded and then ejected and the cartridge error
indicator flashes.
Remove the print paper. Then open the cartridge
compartment lid and replace the used print cartridge
with the new one.
The ejected print paper can be used again.
Push up the eject lever,
then remove the used
v
print cartridge.