Focal FPX 4.800 Manuel D'utilisation page 5

FPX PREMIUM AMPLIFIER
U s e r m a n u a l
5
Installing your FPX amplifier
Installing this product requires technical skill and experience. If you are not sure of your ability to install the
amplifier, entrust this task to a Focal dealer in order to take full advantage of everything your FPX amplifier can do.
Cabling your FPX amplifier
Only use the connection points specified in the user manual and the accessories supplied.
The speaker cable must ONLY be used to connect the amplifier to the speakers. The gauge of the power cables must
match that shown in the table (paragraph 3.1). This gauge depends on the power of the amplifier and the cable length
required. Use double or triple shielded RCA cables to prevent any interference to the low level signal.
Operating time for your FPX amplifier
Avoid using the amplifier for extended periods without starting the vehicle. This can lead to flattening the battery.
Ventilation
It is essential to leave the upper part of your FPX amplifier uncovered to prevent overheating.
Items required for installation (in addition to accessories provided)
• 2 appropriately sized cable sheaths (1 for the power cable and one for the set comprising speaker cables, remote,
RCA modulation)
• Multimeter (volts/amps)
• Soldering iron and solder
• Crimping tool
• Wire stripper
• Wire cutter
• Battery terminal spanner
• Hand drill and drill bits
• Heat shrink sleeving in appropriate diameters for the different cables
• Power cable of appropriate length and gauge
• Remote switch-on wire of appropriate length and gauge (REM input on amplifier)
• Ground (earth) wire of appropriate length and gauge
• Fuse holder and suitable fuse
• Connector to positive (+) battery terminal
• Connector to vehicle chassis (-)
• Bolt with 6 mm head (minimum) with appropriate nut for grounding (earthing) to vehicle chassis
Installation
This section covers points relating to the vehicle that must be taken into account for the installation of your amplifier.
You will save time by planning the positioning of your system and its cabling in advance.
During this preparatory phase, ensure that all adjusters remain accessible once installation is complete.