Domo DO228SV Mode D'emploi page 27

2. Place the hand-held vacuum into the stick vacuum cleaner.
3. Put the stick vacuum cleaner into the charging station, so that the contact points on the vacuum
cleaner are aligned with the contact points on the charging station. Push the vacuum cleaner and
the charging station together so that the stick vacuum cleaner remains standing vertically on the
station. Make sure it all is stable.
4. The battery level indicator will now light up and indicate when the machine is fully charged.
5. The machine cannot be started during charging.
USE
· Press the on-off switch on the handle to turn the machine on. When you switch on the machine, the
rotating floor brush at the bottom of the floor nozzle will begin to turn. This will cause the
opening to be shifted and thereby vacuumed up. The dirt will be collected in the dust reservoir of the
hand-held vacuum cleaner.
· Press the speed control to increase or lower the suction power.
· Press the release button on the hand-held vacuum cleaner to remove the hand-held vacuum cleaner
and only use the hand-held vacuum cleaner. To use just the hand-held vacuum, press the on-off switch
on the hand-held vacuum cleaner.
· The machine is equipped with a safety which will ensure that the machine shuts itself off if, for
example, objects which are too large are sucked up, or if
This is for personal safety and to protect the motor. To reverse the floor brush, press the on/off button
again or press the speed control.
ACCESOIRES
You can attach the following accessories to the hand-held vacuum:
· Dust brush: for furniture, bookshelves, curtains and hard to clean surfaces.
· Crevice vacuum cleaner: for crevices, corners, stairs, keyboards,...
VACUUM AND CLEAN AT THE SAME TIME
With this appliance, you can vacuum and clean at the same time. You must always keep the appliance flat
on the floor for best results. To do this, follow the steps below:
1. Attach the floor cloth nozzle to the floor cloth.
2. Fill the floor cloth nozzle with water using the provided opening. Use the supplied filler cup for this.
Do not to exceed the maximum level of the water reservoir in the floor cloth nozzle.
3. Attach the upright vacuum cleaner to the floor cloth nozzle. You can now vacuum and clean at the
same time.
4. Afterwards, simply remove the vacuum cleaner from the floor cloth nozzle. Make sure there is no
more water in the floor cloth nozzle's water tank.
www.domo-elektro.be
fingers become tangled in the floor brush.
dirt in the
27
DO228SV