Measuring Blood Pressure - Beurer BM 28 Mode D'emploi

3. If alarm 1 is deactivated („off"), you automatically
switch to setting alarm 2
4. If alarm 1 was set to "on," the alarm time hour will
flash at the top of the LCD Display; use the + and -
Buttons to set the desired alarm hour and press SET to
confirm. The alarm minutes will flash; use the + and -
Buttons to set the desired alarm minutes value.
5. After Alarm 1 is set, the Alarm 2
"on" or "off". Set Alarm 2
described above
AC Adapter Operation:
You can also operate this device with an AC Power Adapter
(not included). You MUST remove the batteries before
powering this unit with an AC Adapter. Only use an AC
Power Adapter with specifications according to section
"Power supply unit".
1. Insert the round power plug from the AC Power Adapter
into the AC Adapter Jack on the right hand side of the
blood pressure monitor. Plug the AC Power Adapter into
a standard electrical outlet.
2. When finished using the device, unplug the AC Power
Adapter from the electrical outlet and disconnect it from
the blood pressure monitor. When you unplug the AC
Power Adapter, date and time settings will be lost but
saved measurements will remain.
.
will display
in the same manner as

7. Measuring blood pressure

The blood pressure monitor needs to be at room
temperature when measuring. Measurements can be
performed on either arm.
Positioning the Cuff:
1. Place the cuff round your bare
left upper arm 1 - 1½ in (2-3
cm) above the bend of the
elbow and above the artery,
with the Air Tube in line with the
center of the palm. Ensure
blood circulation is not
restricted by tight clothing or
other objects.
2. Fasten the cuff, making sure it is
not too tight around your arm.
You should be able to fit two
fingers under the cuff after it is
in place.
3. Make sure the index mark (
between the MIN and MAX
markings.
4. Insert the Air Tube Connector into
the Air Tube Port.
11
) is