Main Menu; Startup Menu - LORCH ControlPro Manuel D'utilisation

MMA (ElectrodePlus Package) (optional)
The ElectrodePlus pack contains additional electrode welding
programmes.
 Push the welding process button A32 until
the following symbol appears in the graphic Speed
Up
display A52.
9 A safety prompt appears in the graphic display A52.
Ensure that the electrode or the electrode
holder do not come into contact with the work-
piece or workpiece line.
 Confirm the safety prompt.
‰ The code of the electrode welding programme is displayed
for 3 sec. and then the right-hand 7-segment display A12
switches to the voltage display. Turning the rotary knob
A44 causes the display to switch back to the electrode
welding programme, allowing settings to be made.
 Use the rotary knob A44 to select the desired electrode
welding programme.
‰ The following electrode welding programmes are avail-
able.
Code Electrode welding programme
rut Rutile electrode:
Electrodes with rutile coating
bAS Alkaline electrode:
Electrodes with alkaline coating
CEL CEL electrode:
Electrodes with coating containing cellulose, suitable
for downwards welding
Gou Gouging: Gouging
Tab. 1: Electrode welding programme
TIG (optional)
2)
In the TIG welding process, welding takes place with contact
ignition and a valve torch without a probe.
 Push the welding process button A32 until
the following symbol appears in the graphic
Speed
Up Pulse
display A52.
9 A safety prompt appears in the graphic display A52.
Not available for welding units in the automation sector.
1)
2) Not available for welding units in the automation sector.
- 36 -
1)
Speed
Pulse Manual Synergic Arc
Speed
Manual Synergic Arc MMA
Ensure that the TIG torch do not come into con-
tact with the workpiece or workpiece line.
Speed
 Confirm the safety prompt.
MMA TIG Arc Basic
7

Main menu

The main menu makes all functions, settings and information
available.
 Press the Menu A50 button.
9 The main menu is displayed in the graphic display A52.
 Confirm the menu point by pressing the operating button
A49.
 Confirm the menu point by pressing the operating button
A49.
‰ A description of the menu points is provided in Chapter
"19 Main menu table" on Page 50.
‰ An overview of the menu points is available in Chapter "15
Menu structure Main Menu" on Page 46
‰ A description of the secondary parameters is available in
Chapter "5 Secondary parameters" on Page 35, and in
Chapter "18 Secondary Parameters Table" on Page 49.
 Exit the menu by (multiple) pressing of the Menu button
A50.
8

Startup Menu

The startup menu is available for special functions.
As soon as the machine starts, you will be able
i i
to call up the machine service data using a QR
code or a NFC-compatible mobile phone and
send it by entering an email address.
 Turn off the equipment using the main switch.
Speed  Hold down the Menu button A50 and switch the device on
TIG Arc Basic
at the same time using the main switch.
or
 Press the Crater fill A2 and Weld method A32 buttons si-
multaneously for 3 secs.
9 The NFC active LED A58 lights up.
‰ The QR code, serial number and NFC active appears in
graphic display A52.
909.3059.9-03
Startup Menu
02.20