Control Pro User Interface - LORCH ControlPro Manuel D'utilisation

1

Control Pro User Interface

A1
A40
A58
A37
A36
A35
A34
A33
A32
Fig. 1: Control Pro User Interface
A1
Crater filling LED
Lights up if the Crater filling function is selected
A2
Crater filling button
A3
LED welder (user level 2...8)
lights up with changed user level.
A3b LED Admin (at and above user level 10)
also lights up with changed user level.
A4
7-segment display, left
Displays the selected material thickness, welding cur-
rent or wire feed speed.
A6
Remote control LED
Lights up when a remote control is connected.
- 32 -
A2 A3 A3b
A4 A7
A41
A52
A55
A54
A53
909.3059.9-03
A13
A6 A10 A12
A42
A44
A43
A51 A50 A49
A7
Hold LED
Lights up at the end of a welding process. The most
recently used current strength and welding voltage
are displayed in the 7-segment display (A4 and A12).
A10 Parameter value level display
Up arrow = The set value is higher than the standard
value
Down arrow = The set value is lower than the standard
value
A12 7-segment display, right
Displays the selected welding voltage, arc correction
or electrode material.
A13 Service LED
Lights up should servicing be needed, e.g. calibration
required.
Control Pro User Interface
A14 A15
A16
A59
A19
A20
A21
A45
A46
A47
A48
A56
A57
02.20