Troubleshooting - Zipper Maschinen ZI-BRM52EST Manuel D'utilisation

23 TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause serious
injury or even death. Switch off the machine before carrying out any troubleshooting
work and secure it against unintentional restarting.
failure
Engine does not
start
Engine does not
start at E-start
Engine starts and is
stalled immediately
Machine works with
interruptions
Smoke
Machine does not
work with full
performance
Rough running,
vibrations
Low quality cut
Poor pickup of the
grass
ZIPPER MASCHINEN GmbH
ZI-BRM52EST
WARNING
Possible cause
 Incorrect starting sequence
 Dirty air filter
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not placed on.
 No ignition spark
 No/low battery
 Incorrect idle adjustment
 Carburetor incorrectly adjusted
 Spark plug fouled
 Incorrect fuel
 Carburetor incorrectly adjusted
 Machine overloaded
 Dirty air filter
 Carburetor incorrectly adjusted
 Loose blade screw
 Damaged or unbalanced blade
 Foreign material/grass wrapped, around
the blade
 To high grass
 Wrong cutting height
 Blade worn
 Full grass box
www.Zipper-Maschinen.at
TROUBLESHOOTING
Repair
 Observe the correct starting sequence
 Clean/replace air filter
 Refuel
 Check the fuel line for kinks or
damages
 Screw off, clean and dry the spark
plug. Then pull the cranking rope
several times and reinstall the spark
plug
 Place on the spark plug connector
 Clean/replace spark plug
 Check ignition cable
 Insert/charge battery
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Use correct fuel
 Contact customer service
 Grass too tough
 Clean/replace air filter
 Contact customer service
 Tighten blade screw
 Balance or replace blade
 Remove Foreign material/grass
 Set to correct cutting height
 Set to correct cutting height
 Replace blade
 Empty grass box
35