Checking Fuel Tank Level / Refuelling Fuel Tank; Operation; Informationen On Initial Start-Up; Test Run Initial Start-Up - Zipper Maschinen ZI-BRM52EST Manuel D'utilisation

Masquer les pouces Voir aussi pour ZI-BRM52EST:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16.3.2 Checking fuel tank level / Refuelling Fuel Tank

Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
Process:
1. Screw on the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection. If necessary, top up petrol with
3. Close the filler cap tightly after refuelling.
17

OPERATION

Only put the machine into operation after you have read and understood the safety instructions and
carried out the necessary measures before initial commissioning..

17.1 Informationen on Initial Start-up

The machine is delivered without engine oil and fuel. Make sure that this
equipment is filled up before the machine is put into operation for the first time.

17.1.1 Test Run Initial Start-up

Let the machine run idle for about 3 minutes.
Watch out for abnormal noises.
Pay attention to the exhaust fumes (too black, too white)?

17.1.2 Notes for the first 20 operating hours

In order to optimize the life expectancy of your machine, the following points should be observed:
ZIPPER MASCHINEN GmbH
ZI-BRM52EST
1.
To check the engine oil level, place the machine on a safe,
level surface. Switch off the engine and allow the machine
to stand for ten minutes so that the circulating oil can
collect in the oil pan.
2.
Unscrew the oil dipstick and wipe it with a clean, lint-free
cloth or a non-fibrous paper towel.
3.
Push the measuring rod back into the opening as far as it
will go, but do not screw it in. (Make sure that the rod has
really been pushed in completely - sometimes it cants
itself).
4.
Pull out the oil dipstick again and read off the oil level.
There are two markings for this - see illustration on the left.
5.
If the oil level is low, top up recommended oil to the upper
limit (maximum filling volume according to technical data).
6.
Insert the oil dipstick again and tighten it.
NOTICE
the appropriate octane number (RON 95) (maximum tank volume according to
technical data).
NOTICE
www.Zipper-Maschinen.at
OPERATION
28

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

9120039233154

Table des Matières