Starting Operation - Bosch PSR Select Notice Originale

34 | English
Changing the Tool (see figure D)
Wear safety goggles when changing the tool. Do not look directly into
the tool holder. When changing the application tool, there is a possibility
that it may be ejected outwards.
Turn the bit magazine (11) until the required screwdriver bit (1) is visible in
the viewing window (3).
Push the sliding switch (7) forwards.
Operation

Starting Operation

Set the rotational direction (see figure E)
The rotational direction switch (8) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (10)
is being pressed.
Right rotation: To drill and to drive in screws, press the rotational direction
switch (8) through to the left stop.
The rotational direction indicator for right rotation (4) lights up
when the on/off switch (10) is pressed and the motor is run-
ning.
Left Rotation: To loosen and unscrew screws and nuts, press the rotational
direction switch (8) through to the right stop.
The rotational direction indicator for left rotation (6) lights up
when the on/off switch (10) is pressed and the motor is run-
ning.
Switching on/off
Note: The power tool can only be switched on if the sliding switch (7) has
been pushed forwards.
To start the power tool, press and hold the on/off switch (10).
The lamp (12) lights up when the on/off switch (10) is lightly or fully
pressed, meaning that the work area is illuminated in poor lighting condi-
tions.
To switch off the power tool, release the on/off switch (10).
The drill spindle is locked when the on/off switch (10) is not pressed.
1 609 92A 4M5 | (24.10.2018) Bosch Power Tools