Description Of The Front And Back Panels; Mains Socket - SOPRO COMEG SYMBIOZ CAM Manuel D'utilisation

7
DESCRIPTION OF THE FRONT AND
BACK PANELS

7.1 MAINS SOCKET

The camera receives electrical power by means of the mains plug located on the back panel
[C2], which must be connected to the mains power supply by the lead supplied with the came-
ra. This plug carries a fuse trap as well as a master switch for turning on the apparatus. The
camera uses T2.5AL - 250V fuses.
When replacing a fuse, the camera must be unplugged and the same type of fuse must be used.
The T in "T2.5A" means "time-delay". Only use fuses marked UL/CSA.
7.2 VIDEO OUTPUT PORTS
The following video output ports are available on this camera: DVI [C6], HD-SDI [C8], RGBS
[C5], Y/C [C10] and composite [C11].
The DVI output port provides the best image quality in 1080p format over short dis-
tances. HD-SDI output ports are used to transport the video signal over long distances
(screen at a distance of up to 50 m...)
7.3 PERIPHERAL OUTPUT PORTS
Two (2) peripheral output ports are available [C12] and these are used with a 3.5 mm jack lead
for managing two peripherals (for example: a printer and a video recorder) from the buttons on
the camera head.
The apparatuses connecting to the "VIDEO OUT" and "PERIPHERAL" ports must be
compliant with standard IEC 60950.
7.4 KEYS AND SYMBOLS ON THE BACK PANEL
The keys and symbols on the back panel are for identifying the camera in accordance with inter-
national standards IEC 60601-1, IEC 60601-2-18, IEC 60417 and EN 980 (See Appendix 1)
The table below describes the back and front components
C1 Connector for the Camera head
C2 Main power socket
C3 RS232 output port (connection to Panasonic EJ-MLA26E surgical monitor)
C4 Service line
C5 RGBS video output port
C6 DVI-D video output port
C7 Equipotential socket
C8 Ethernet output port (Connection to the Sopro insufflators)
- 22 -