Installing The Apparatus - SOPRO COMEG SYMBIOZ CAM Manuel D'utilisation

5

INSTALLING THE APPARATUS

This medical device is intended for use by a qualified surgeon during endoscopic exploration.
No special training is required to install it. Kindly refer to the instructions in this manual.
Place the control unit on its base and have to hand the various accessories required to operate
it.
• Connect the power cord to the mains socket of the camera [C2] and a video lead to one
of the video output ports: We recommend selecting the DVI output [C6] for connecting the
main surgical monitor.
• Connect the second end of the video lead to the video input port on the monitor.
• If you wish to control certain functionalities of the Sopro insufflator or the Sopro light source,
connect these to the SOPROCOM socket on the camera's control unit [C9] intended for this
purpose, using the two cables provided.
Connecting the endoscope to the sensor
• Turn the ring on the endoscope-holder on the camera head clockwise.
• Once the endoscope is inserted, release the ring.
• If the sensor has to be locked into position on the endoscope, the ring should be turned in
the opposite direction.
• Connect the potential equalization cable to the equipotential plug C13 at the back of the
apparatus.
To optimize the quality of the images obtained with this product, always be sure to connect
the camera head before turning on the control unit.
• Connect the power cable to the plug [C2] at the back of the camera.
• Connect the DVI-D cable to the corresponding output port [C6] at the back of the product and
to the corresponding input port on the monitor.
a The HDSDI output produces a progressive 1080 signal
• If needed, connect other monitors or peripherals, preferably using the HDSDI output ports
[C8]
a HDSDI output ports produce an interfaced 1080 signal
a HDSDI output ports are preferred when a very long cable is necessary.
5.1 CONNECTIONS
5.2 ACTIVATION
- 13 -