Operation - Cameo CL 200 Manuel D'utilisation

OPERATION

As soon as the spotlight is correctly connected to the power supply, the following will be displayed in succession: "Welcome to Cameo", the
model name and the software version. After this process, the spotlight is ready for operation and starts in the previously selected mode. If the
DMX operating mode is activated and there is no DMX signal at the DMX input, the display will start to flash after a few seconds. After approxi-
mately 1 minute of inactivity, the display will automatically show the currently active operating mode.
SET DMX START ADDRESS (DMX Addr)
Press the MODE button repeatedly until "Menu" appears in the top line of the display. If necessary, select the menu item "Menu DMX Addr" using
UP and DOWN and press ENTER. Now select the desired DMX start address using UP and DOWN, and press ENTER to confirm.
Menu ENTER
DMX Addr
UP/DOWN
SET OPERATING MODE (Mode)
Press the MODE button repeatedly until "Menu" appears in the top line of the display. If necessary, select the menu item "Menu Mode" us-
ing UP and DOWN and then press ENTER. Now select the desired operating mode using UP and DOWN and confirm with ENTER (see tables,
note sub-menus). The comprehensive DMX tables can be found in these instructions under "DMX CONTROL".
Operating Modes
Mode DMX
Mode Slave
Mode Static
Menu ENTER
Mode
UP/DOWN
6
DMX Addr
001–512
= DMX operating mode
= slave mode
= set a "scene" without an
external controller.
Mode DMX Mode
ENTER
DMX
DMX Mode
/
Mode
ENTER
Slave
/
ENTER
Mode
Static
UP/DOWN
ENTER - UP/DOWN
ENTER
1CH = 5 different DMX modes to choose from. DMX tables –
2CH_1 see "DMX CONTROL".
2CH_2
3CH
4CH
Slave = connect DMX IN on the slave unit to DMX OUT on the
master unit (same model) and enable the standalone
mode "Static" on the master unit. The slave unit will
now follow the master unit.
Static = dimmer, stroboscope (approx. 1–30 Hz), cold white and
warm white can be adjusted individually to settings
between 000 and 255.
DMX Mode
/
1CH 2CH_1
DMX Mode
/
3CH 4CH
Dimmer Strobe
-
ENTER - UP/DOWN
Dimmer Strobe
000 - 255 000 - 255
ENTER ENTER
DMX Mode
/ /
2CH_2
ENTER
Warm Colde
- -
white
ENTER - UP/DOWN ENTER - UP/DOWN
W-White C-White
000 - 255 000 - 255
ENTER ENTER
white