Step 5:
Installing the TV
WARNING
Be sure to complete the installation before connecting the
mains lead to the wall socket. If you allow the mains lead
to be pinched under or between pieces of equipment, this
may result in a short circuit or an electric shock.
Be careful not to stumble over the mains lead or the TV,
as you may hurt yourself.
1
Change the position of the
woofer speaker.
1 Loosen the four screws (two on each side of
the strut arms) used to secure the woofer
speaker in place about three turns.
2 Slide the woofer speaker upward completely
as shown below.
3 Retighten the four screws (loosened in step
1) to secure the woofer speaker.
Loosen (but do not
remove) the screws.
Note
If you fail to slide the woofer speaker completely in
step 2, the woofer speaker connector locating at the
center bottom of the rear side of the TV and
ventilation holes will be blocked resulting in product
damage.
Soft cloth
2
Hitch the Mounting Rack on the
hooks on the rear side of the TV.
Then slide the Mounting Rack
and fix it using the supplied
screws (+PSW5 × L14).
Rear of the TV
Soft cloth
Note
The woofer speaker connector is located on the lower
right part of the Mounting Rack. When sliding the
Mounting Rack, make sure that the woofer speaker is
securely connected to the TV.
Woofer speaker connector
11
(GB)