Wolf PRO WALL Guide D'utilisation Et D'entretien page 6

WA LL H O O D F E AT U RE S
Pro Wall Hood Features
F E AT U R E S
1 Product Rating Plate (inside hood shell)
2 Recessed Controls
3 Filters
Halogen Lighting
4
1
2 4
Wall ventilation hood.
|
6 English
WALL HOOD O PERATI ON
Hood Controls
Controls for pro wall ventilation hoods are recessed under
the front edge of the hood. Refer to the illustration below.
LIGH TS
The control knob on the left operates the halogen lights.
From the (OFF) position, turn the knob to the left for
(LOW) and right for the (HIGH) light setting.
H EAT LAMP
If equipped, the center control knob operates the heat
lamps. Each lamp can be controlled independently or simul-
3
taneously. Turn the knob to the left, right or center to select
desired setting.
B LO WER
The control knob on the right operates the blower with
infinite control of blower speed. To turn the blower off, turn
the knob counterclockwise.
BLOWER
HEAT
LAMPS
LIGHTS
Hood controls.
Heat Sentry
The heat sentry feature automatically turns the blower on
or increases blower speed when the exhaust temperature
exceeds 95°C. It automatically adjust blower speed to the
previous setting once the temperature drops below 85°C.
Lighting
LI GHT BU L B RE P L A CE ME N T
Pro wall ventilation hoods require GU 10 (50W maximum)
halogen light bulbs, available through an authorized Wolf
dealer.
A suction-cup-style light bulb changer is provided with
the ventilation hood. To remove a bulb, use the changer to
rotate the bulb counterclockwise one-quarter turn. Refer to
the illustration below.
LIGHT BULB
CHANGER
Light bulb replacement.
Heat Lamps
For 686 mm deep wall hoods, two heat lamp receptacles
require E27, R125 (250W maximum) bulbs. Bulbs are
available at hardware stores or through an authorized Wolf
dealer.
Allow the heat lamps to cool before replacing bulbs.
Unscrew the bulb to replace.
CAUTION
Use caution when replacing heat lamp bulbs. Adjacent
parts of the ventilation hood may retain heat.
Filter Removal
The filters are dishwasher safe. Refer to care recommend-
ations.
Remove the center filter first. To remove, press filter upward
then rotate the bottom downward. Refer to the illustration
below. Remove grease cups from the bottom edge of the
hood. Gloves should be worn when handling filters.
Reinstall using the reverse procedure. Slide outer filters over
slightly to reinstall the center filter.
IMPORTANT NOTE: Do not operate the ventilation hood
without filters. This may damage the blower or other internal
components of the hood.
SPRING GREASE
CUP
FILTER
SIDE VIEW
Filter removal.