Maintenance - SATA 100 prep Mode D'emploi

Operating Manual SATA filter 100 / 101 / 103 prep
EN
Note!
Fine filter cartridge:
• Special micro fibre fleece
• Fineness 0.1 µm, separation degree 99.998 % related to a particle
size > 0.1 µm
• Surface 300 cm²
9.3. Filter stage [C]:
Except for the installed filter cartridge, the design of the third filter stage is
identical to the second filter stage [B]. This third filter stage contains the
activated charcoal cartridge (Art. No. 157362). The activated charcoal
filter can only be used with the filter stages [A] and [B] preceding.
Note!
Activated charcoal filter cartridge:
• Fibre-bound activated charcoal
• Surface 300 cm²
9.4. Air outlet module [D]:
The desired starting pressure can be finely adjusted on the pressure
regulator [1-4] using the pressure adjusting knob [1-5] and read on the
pressure gauge [1-3]. The pressure regulator ensures constant starting
pressure. The branch pipe is equipped with 2 ball taps [1-6], connecting
threads G ¼ (external thread).

10. Maintenance

• Filters can only be maintained and serviced when depressurised!
• Sintered filter [A]/Art. No. 22160 and filter housings [1-8], [1-12]
have to be cleaned after 6 months at the latest; replace sintered filter,
if necessary!
• The fine filter cartridge [B]/Art. No. 148270 has to be replaced
every 6 months at the latest!
• The activated charcoal cartridge [C]/Art. No. 157362 has to be
replaced every 3 months at the latest!
66
Warning! Attention!