CE Source Four Zoom instructions
Safety warnings
The CE Source Four Zoom high performance ellipsoidal spotlight is
intended for professional use only. Read entire User Manual before
using equipment. Please note the following safety warnings before
use:
• Do not mount the CE Source Four Zoom on or near a flammable
surface.
• Use the luminaire in dry locations only, where humidity does not
exceed 90 percent. Luminaire is not intended for outdoor use.
• Mount and support the luminaire only by the primary suspension
yoke holes. Suspend the luminaire from a hook clamp or a stand
mount, using a securely tightened steel bolt (up to 12 mm Ø),
washer and locking nut.
• In addition to primary suspension, attach a safety cable (Model
400SC) or chain to the secondary suspension point on the luminaire
(see page 4).
• Open all four shutters completely before turning the luminaire on.
• Always hang the CE Source Four Zoom with the colour frame
retaining clip in the locked position.
• Always replace the lamp if it becomes damaged or thermally
deformed.
• Keep the luminaire at least 0.7 meters away from anything it is
shining on.
• Lighted objects at this distance or greater will not exceed 90ºC
temperature from projected light.
• Disconnect the unit from power before all cleaning and
maintenance.
• Maximum ambient temperature: T
• Maximum exterior surface temperature: T
• A multilingual label sheet is included with this manual. Affix the label
of the appropriate language over the existing warning label on the
extension yoke. Do not cover ETC trademark or CE mark.
=45 ° C
a
=200ºC
max
0.7m
CE Source Four Zoom • 7
English