Triton TGEOS Instructions D'utilisation Et Consignes De Sécurité page 9

4. Fit the flat end of the Dust Extraction Port back into the gear housing
5. Reattach the Dust Extraction Port Screw and tighten by hand, using a
suitable Phillips screwdriver
Note: If, after cleaning, dust extraction still does not operate properly, the
Hook and Loop Backing Pad should be removed to clean and inspect the dust
channels through the Hook and Loop Backing Pad (2) and gear housing (see
'Fitting the backing pad).
Maintaining the backing pad brake
• In free-run mode, the rubber collar, located between the Hook and Loop
Backing Pad (2) and the metal gear housing (see Fig. A), controls the
acceleration of the backing pad, when the tool is switched on, until the
Hook and Loop Backing Pad reaches its maximum speed
• The collar wears down with use, and has to be replaced when the braking/
control performance is reduced (see 'Fitting the backing pad' for removal/
replacement)
• Contact your authorised Triton service centre for spare parts or
replacement service
Hook and loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter,
such as hair, fibres, sand etc.
• In order to provide adequate adhesion for securing accessories, hook and
loop surfaces must be in good condition
• When used extensively, hooks and loops will become elongated or broken,
and the mechanism cannot provide the required strength of adhesion
anymore
Note: This sander's hook and loop Hook and Loop Backing Pad is NOT a
warranty item. Replacement backing pads can be obtained as spare parts
through an authorised Triton service centre.
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or
visible sparking
• To replace the brushes, remove the Carbon Brush Access Covers (9)
from both sides of the machine. Remove the worn brushes and replaced
with new. Replace covers. Alternatively, have the machine serviced at an
authorised Triton service centre
Storage
• Store this tool and its accessories after use in its case, in a dry, secure
place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are
no longer functional and are not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools and batteries
GB
9