TERMA MEG Mode D'emploi page 15

MEG
temperature regulation
turn on / off button
Turning on the device will result in the
heating of the radiator up to the set tem-
perature. After reaching the set tempera-
ture the device will turn off and on regular-
ly in order to maintain the set temperature.
The construction of the device as well as
the physical characteristics of the heating
agent inside the radiator influence the way
in which the heat is distributed — the tem-
perature of the bottom pipes on the radia-
tor (especially the two located at the very
bottom of the radiator) may be lower than
the temperature of the remaining parts of
the radiator — this is normal.
Temperature increase
In order to increase the temperature of the
radiator, press once or several times as
required; the right number of diodes will
start blinking. The last blinking diode indi-
cates the set temperature, whilst the last.
EN
Temperature decrease
In order to decrease the temperature of
the radiator, press
as required; the right number of diodes will
start blinking. The last diode that which
shines constantly indicates the set tem-
perature whilst the last blinking diode in-
dicates the current temperature. The fol-
lowing diodes will start fading on reaching
subsequent temperature levels.
Anti-freeze function
(anti-freeze protection)
When the device is off and the tempera-
ture around temperature sensor drops
down below 6° C, the device will switch on
automatically. This is to prevent the heat-
ing agent inside the radiator from freezing.
Activating Anti-freeze mode is indicated by
winking of the middle diode.
once or several times
15