Autotrol 255 Manuel D'utilisation page 33

Filter Configuration
Level 2 Programming
Parameter Parameter description
P1 Time
P2 Day of week
P3 Time of Regen
P4 Forced Regen Interval
P5 Regen Interval (only 742)
P6 Backwash time
P7 Volmetric capacity
P9 Unit of measure (0=english , 1= metric)
P10 Clock mode
P11 Service internal
P12 Remote regen sw. Delay
P13 Chlorine generator (0=non, 1=salt check only, 2=generate chlorine and check salt)
P14 Refill rate
P15 Brine Draw rate
P16 Reserve type
P17 Reserve percentage for fixed reserves %
P18 Flow sensor select
P19 K factor or pulse equivalent
Note : In level 2 programming, you can individually lock the parameters P1 to P8 by pressing the Regen
button. In this case, in level 1 programming, the parameters can be viewed and a Locker symbol indicates
you that the parameter can no longer be changed in level 1.
Unit
HH:MM
Days
HH:MM
Days
only 742 - Days if P4 set to 0
Minutes
Cuft if P9=0 ; m3 if P9=1
(0=12h ; 1=24h)
Monthes
s
gpm x 100
gpm x 100
0=variable reserve,
Delay regen-1=Fixed reserve
Delay regen-2=Variable reserve
immediate regeneration,3=Fixed reserve
immediate regeneration
0=internal turbine, Magnum IT NHWB
1=1"Autotrol turbine, 2=2"Autotrol turb.
3=User defined K factor, 4=User defined
pulse equivalent, 5=Magnum IT HWB
pulses/gallon (P18=3 AND P9=0)
gallons/pulse (P18=4 AND P9=0)
pulses/liter (P18=3 AND P9=1)
liters/pulse (P18=4 AND P9=1)
33
Feature used Feature used
in 742 for in 762 for
263 and 273 263 and 273
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes Yes
No Yes (not modif.)
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Not used Not used
Not used Not used
Not used Not used
Not used Yes
Not used Yes
Not used Yes
Not used Yes
Not used Yes
Not used Yes
Not used Yes
En