Initial Start-Up Step-By-Step Instructions - Autotrol 255 Manuel D'utilisation

INITIAL START-UP STEP-BY-STEP INSTRUCTIONS

For FA filter applications, please program as normal below.
See section Programming the 700 for 5-Cycle Filter Applications.
Step 1: Select Valve Type
This step may have been performed by your system's OEM manufacturer.
In this case, proceed to step 3.
• Identify your valve body type by looking at the silver ID sticker on the back or side of
the valve body.
• Select your valve body type using the UP and DOWN buttons.
• Display
255
263
268
273
278
293
298
NOTE: Different 742/762 control hardware is necessary to operate the 150S
valve body.
Step 2: Program System Size
NOTE: Capacity is the result of the amount of media in the tank and the salt
setting. The default capacity will be changed by selecting a different regene-
rant setting.
• Input system size – media volume (For FA filters, choose your closest media volume) –
in cubic feet or liters.
• Use UP and DOWN buttons to scroll through resin volume choices.
• Choose the nearest volume to your actual system size.
• Press SET to accept the system size you've selected.
• If incorrect setting is programmed, see "Resetting the Control" section below.
Valve Body
255, 7-cycle conditioner
Performa filter 263, 3-cycle filter
Performa conditioner 268, 7-cycle conditioner
Performa Cv 273, 3-cycle filter
Performa Cv 278, 5-cycle conditioner
Magnum Cv filter, 3-cycle filter
Magnum Cv conditioner, 5-cycle conditioner
This step may have been performed by your system's OEM manu-
facturer.
In this case, proceed to step 3.
23
En